Stainless steel stirring tank is often used in the daily chemical industry, the same high shear emulsifying tank is also one of the commonly used equipment, so it sounds also mixed function, what is the difference between them? Here is a brief introduction to the difference between the two.

Agitation tank is usually applied in wash protect products, such as shampoo, shower gel, detergent, laundry detergent, etc., the former two is the need for heating function, general under 1 ton drum to basically is by electric heating rod heating, more than 1 t recommend basically is to use steam for heating more cost-effective, the drum and the larger the difference is that one is the emulsifying tank sealing, one is half open, The homogeneous mixing function is provided by the mixing tank, and vacuuming does not belong to the function of the mixing tank, but the mixing tank can basically solve the production of most daily chemical products.

High shear emulsifying tank is simple it can be called a stationary mulser, emulsifying tank with heating function is generally three layer heated, the first layer is in contact with the material of 316 l material, the second layer for insulating layer is mainly isolated from the heating medium (water or oil), if you choose another gauge of steam for heating, emulsifying tank can configure homogenizer, Also have to write the product at the time of production is not to need to homogenizer, the role of the homogenizer is the material of high speed shearing emulsification, generally in the production of high frost on homogeneous emulsion latex products demand will be high, so the clearance between stator and rotor homogenizer, have often been used to compare the stand or fall of an emulsion tank, emulsifying tank configuration of pumping air into vacuum state, the basic configuration of this basic is emulsifying pot, It is mainly to achieve the role of defoaming in production engineering, so in the manufacturing process if most of the bubbles are produced when stirring, we can take vacuum defoaming, and focus on vacuuming can also use negative pressure to achieve vacuum suction, which is also a more extensive function in practice production. As for the stirring function and the stirring tank are roughly the same speed at 0-63R, the speed can be customized for special requirements. The main thing is that the size of the production tank and the size of the motor are more important.